Industrial belt joint bonding method:

1.Mechanical joint, a refers to the use of buckle joint, which is convenient economic. If the belt is damaged in the application process, the buckle joint is easy to change if you want to change a new belt, but the efficiency of the joint is low easy to damage, which has a certain impact on the service life of the belt product.

2. Cold bonding joint, that is to use cold bonding adhesive to stop the joint, with adhesive as the raw material, to connect the two ends of the conveyor belt together. The key to the cold bonding effect depends on the glue used, whether there is seamless treatment. Because this method has the advantages of high joint strength, no noise, no vibration, complex operation short joint time, it is widely used. However, theoretically, it is difficult to master the process conditions, the quality of the adhesive has a great impact on the joint, so it is very volatile. In addition, the cold adhesive conveyor belt is suitable for materials with wet temperature requirements 。

3. The conveyor belt interface of the thermal vulcanization joint the thermal vulcanization joint is completely blocked is easy to be wetted by water. The process of the belt vulcanization joint is generally to place the lower frame of the vulcanizer on the belt frame, align the two ends, then place the water pressure plate, small heat insulation plate lower heat insulation plate in sequence. Each side of the two vulcanizers is equipped with a 1-2m platform fixed. The upper surface of the platform should be flush with slightly lower than the upper surface of the lower heating plate, the tension of the pull rod should be affected, the two joints of the belt should be placed flat Stop vulcanization at the beginning of the stage. This method is the most ideal joint method at present, which can ensure high joint efficiency, but also very fluctuant. The joint life is also very long easy to master. However, the hot vulcanization joint process is complex, which requires high personnel. The cold bonding process is complex short-term training is available