Correct use of grease

1. Proper lubrication

If the amount of grease is too much, the friction torque will increase, the temperature will increase, the consumption of grease will increase; if the amount of grease is too little, reliable lubrication will be obtained, dry friction will occur. In general, an appropriate amount of grease should be 1 / 3 to 1 / 2 of the total void volume in the bearing. However, depending on the situation, sometimes the bearing edge should be greased for cavity lubrication.

2. Pay attention to prevent mixing of different types, brands new old lubricating grease

Avoid cross use of grease containers tools, which can cause adverse effects, such as reduced fat, increased permeability reduced mechanical stability.

3. Pay attention to replace with new grease

Due to the continuous improvement change of the type quality of lubricating grease, the old equipment shall be tested before formal use; when replacing new grease, the waste grease shall be removed the clean parts shall be cleaned. When replenishing the grease, the waste grease shall be extruded until new grease is seen at the grease outlet.

4. Pay attention to the management of grease injection process

Pay close attention to the cleaning of containers tools before receiving adding grease. The grease supply port on the equipment shall be wiped in advance to prevent mixing of mechanical impurities, dust sand.

5. Pay attention to timely change seasonal grease

If the environment of the equipment changes greatly between winter summer, the temperature difference is large, if winter grease is used in summer, vice versa, the result will be the opposite.

6. Pay attention to add lubricating grease regularly

The adding changing time of lubricating grease shall be determined according to the specific service conditions to ensure reliable lubrication without waste of lubricating grease.

7. Do pack grease in wooden cases cartons

       Prevent oil loss hardening, mix with water pollute deteriorate, store in a cool dry place.